EnGenius ECB9500 Manual de usuario descargar pdf (Pagina 10)

Multi-Function Gigabit Wireless-N Client Bridge Version 2.0

2. Select Internet Protocol (TCP/IP) and then click on the Properties button. This will

allow you to configure the TCP/IP settings of your PC/Notebook.

3. Select Use the following IP Address radio button and then enter the IP address

and subnet mask. You may follow the example below. Please Ensure that the IP

address and subnet mask are on the same subnet as the device.

For Example: Device IP address: 192.168.1.2

PC IP address: 192.168.1.21

PC subnet mask: 255.255.255.0

4. Click on the OK button to close this window, and once again to close LAN properties

window.

3 Web Configuration

3.1 Logging In

 To configure the device through the web-browser, enter the IP address of the Bridge

(default: 192.168.1.2) into the address bar of the web-browser and press Enter.



Make sure that the device and your computers are configured on the same subnet.

Refer to Chapter 2 in order to configure the IP address of your computer.



After connecting to the IP address, the web-browser will display the login page.



Enter admin for both the user name and password.

 After logging in you will see the graphical user interface (GUI) of the device. The

navigation drop-down menu on left is divided into five main sections:

1. System: This menu includes the status, schedule, event log, and monitor.

Wireless: This menu includes status, basic, advanced, security, WPS, Client list,

VLAN, and WMM. Through this section, you can also change the device operating

mode, such as Access Point, Client Bridge, WDS Bridge, or Universal Repeater.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 63 64

Sin comentarios

EnGenius ECB9500 Manual de usuario Pagina 10