EnGenius ETR9360 Manual de usuario Pagina 70

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 121
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 69
69
Advanced
Fragment
Threshold:
Specifies the size of the packet per fragment. This function can reduce
the chance of packet collision.
However when this value is set too low, there will be increased
overheads resulting in poor performance.
RTS Threshold:
When the packet size is smaller than the RTS Threshold, then the
packet will be sent without RTS/CTS handshake which may result in
incorrect transmission.
Beacon Interval:
The time interval that the device broadcasts a beacon. This beacon is
used to synchronize all wireless clients on the network.
DTIM Period:
A Delivery Traffic Indication Message informs all wireless clients that
the access point will be sending Multi-casted data.
N Data Rate:
You can limit the transfer rates between the device and wireless clients.
Each Modulation Coding Scheme (MCS) refers to a specific transfer
speed.
Channel
Bandwidth:
Set whether each channel uses 20 or 40Mhz.
To achieve 11n speeds, 40Mhz channels must be used.
Preamble Type:
A preamble is a message that helps access points synchronize with the
client.
Long Preamble is standard based so increases compatibility.
Short Preamble is non-standard, so it decreases compatibility but
increases performance.
CTS Protection:
When Enabled, the performance is slightly lower however the chances
of packet collision is greatly reduced.
Tx Power:
Set the power output of the wireless signal.
Vista de pagina 69
1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 120 121

Comentarios a estos manuales

Sin comentarios